3D High Density Plastisol Ink - 5 Gallon - Golden Yellow
Need to create a 3D effect, but don’t know where to start? Check out the 3D Series from Total Ink Solutions.
3D High Density Plastisol Ink Series
Total Ink Solutions 3D Series is a phthalate free plastisol ink that has extremely vibrant colors, and a high-density formulation to create amazing 3D printing effects. This is the solution needed for all of your 3D effect printing.
- Vibrant colors.
- Creamy Inks.
- High-Density 3D Effect
50% Cotton / 50% Polyester
Please Allow 48 hours for this product to ship, since it is custom made at the time of order.
When direct printing over dark garments no under base is required. The thickness and density of the ink will prevent the dye migration from occurring. Make sure to use a capillary film as suggested below. This is crucial for the printing of the High Density Ink.
It should be made with thick capillary film between 200 and 1000 microns.
Mesh between 15 to 86T monofilament polyester is recommended.
Flash at 250°F (121°C) for 3 - 5 seconds and cure at 320°F (160°C) – 330°F (165°C). ** NOTE: Excessive Heat applied to 3D print will result in cracking of prints
Store at 65-90°F (18-32°C), avoiding direct sunlight. Best Use within one year of manufacturing date.
In Compliance with CPSIA (Consumer Product Safety Improvement Act) 2008 Section 101 Lead Content in substrates (<300 ppm lead) as Section 108 Phthalates (<.1% DBP DEHP,DINP,DIDP)